Develop an alternate method of glass joint assembly which is universal for all designs and shapes
Any wristwatch has three major components, namely,
In watch case assembly, case center, back cover (BC), case pipe (CP), and glass are assembled on the watch case blank (made of metal) and later tested for joint-strength and water resistance (WR). The WR test is a mandatory statutory requirement for watches and is done through a water immersion method where watch cases are soaked in the water for 10 minutes with the pressure of 5 Kg/cm2 or 7 Kg/cm2, based on specification.
To attain this WR property, all the joints mentioned above should have specified strength i.e. glass joint to withstand a minimum of 4 Kg/ cm2, BC joint to withstand a minimum of 5 Kg/ cm2 and CP to withstand minimum pressure of 3 Kg/ cm2. This strength will ensure the mating parts are intact when the watch is worn while riding a two-wheeler, running, jumping, etc., as well as resisting entry of water/moisture during testing/use because of outside pressure being higher.
As per horology standard and know-how, a glass joint is made by either of the following methods:
Each of these methods will have a certain advantage for each kind of design or configuration and quality. Based on the design of the watch case, the type of joint mechanism to be employed is chosen. Adhesive type joint is to be used:
1. If the model case is shaped and there is no housing/wall for the glass
2. Corners are sharp
3. Glass is having a gradient
However, with the adhesive type joint being used currently, moderate WR is achieved. Also, the failure of watch cases is more prominent in this type. Thus, we are looking for alternate adhesives that can address these problems. Hence, the challenge is to ideate and implement an alternate innovative method of adhesive type joint between the glass and metallic parts, which is universal for all designs.
This will result in the flowing:
Options Tried:
Solution Requirements: